Need Flat Roof Leak Detection?

Need Flat Roof Leak Detection?

The first thing you should do when you notice a leak on your flat roof is to check the inside of the ceiling and walls. Look for wet spots, peeling paint, dripping sounds, and an increase in your water bill. If these signs occur, you may have a plumbing leak that needs to be repaired. If you suspect a leak in the roof, turn off the water to your house for at least 3 hours. Once the time has passed, turn it back on and note how much water is going to be used. If the leak is not visible, you may have to hire a professional to inspect your home.

The best time to inspect your roof is during the night, after the sun has set and after two or three days without rain. This is because the sun’s heat will warm the surface of your roof, and areas where water is located under the surface of the roof will warm up more slowly. This is because the water has a higher thermal capacity than the insulation, so it absorbs heat slower than the rest of the roof. Therefore, if you notice a spot that isn’t warming up, you probably have a leak in your roof.

A leak in your flat roof may appear as brown water spots on the ceiling. The exact source of the leak can be anywhere on your roof, depending on the type of roofing material. If the brown water spots are not caused by the material, the leak may be a seam in the roofing material. If the nails are missing, or if there is excessive rust in the screws that hold the roof together, you may also have a leak. Be sure to check the gutters around your flat roof as well.

If you need a FREE Estimate on Flat Roof or Foam Roof Repair contact our Foam Expert Roofing Specialist for help!

Share this post!